14.12.2009

AS-Interface cable clamp

Back

This cable clamp can be used to connect flat cables to AS-Interface devices with M20 x 1,5 connecting thread. As this cable isn’t easy to handle this clamp can be positioned. This is done by screwing the clamp into the thread and by then fixing the nut against the housing. Afterwards the cable is put into the lower part of the connector and then fixed with two screws to the upper part. When doing so the contact pins are pierced through the cable coating into the cable core. It is possible to mark these connectors by clipping a little label into the upper part of the connector. The connection to the housing is done via two 0,25 mm² single wires. This clamp are already available with  PG 9 and M16 x 1,5 fixing threads.